Jetta L4-2.0L (BEV) (2004)
-
Marking see Fig. 6
-
Installing seal -item 10
12. Bolt, 10 Nm
13. O-ring
-
Always replace
14. Conductor strip
-
With cable transition piece and connector
-
Can be removed and installed with transmission installed
15. Retaining bracket
-
For the conductor strip connector installing see Fig. 11
16. Bolt, 20 Nm
17. Plug for solenoid valves
-
Pull off solenoid valves with 3373 see Fig. 3
18. Sealing plug
-
Take out before removing and installing freewheel
-
Insert so that tab is located In groove on housing see Fig. 5
-
Place O-rings onto sealing plug
19. O-ring
-
Always replace
20. O-ring
-
Always replace
21. Operating rod for manual selector valve
-
Unhooking see Fig. 4
-
Install with stepped side facing manual selector valve see Fig. 7
-
Adjusting see Fig. 8
Fig. 1 Draining ATF
-
Place container under transmission.
-
Remove plug -2-.
-
Remove overflow pipe -1- and allow ATF to drain.
-
Screw overflow pipe in onto stop.
Fig. 2 Replacing plug seal
-
Cut open seal -arrow- with side cutting pliers, always replace seal.
-
After repairs fit new seal to plug and screw in hand-tight when filling with ATF.
-
Fill with 3 liters of ATF then check ATF level and top-up.