Jetta L4-2.0L (BEV) (2004)
Fig. 6 Identification of valve body
Code letters are stamped on a metal tab. Metal tab must remain on valve body.
Allocation of valve body/transmission
Fig. 7 Hooking operating rod onto manual selector valve
-
Turn manual selector valve -1- so shoulder is to operating rod.
-
Guide operating rod -2- with manual selector into valve body.
Fig. 8 Adjusting operating rod for manual selector valve
-
Move selector shaft to position "P".
-
Push operating rod with manual selector valve into valve body as far as stop (direction of arrow) and tighten bolt to 4 Nm.
Note:
-
The manual selector valve must always be resting against the stop. Counter-hold in the direction of the arrow when tightening the bolt
-
Always replace the bolt and the manual selector valve retaining clip.