Jetta V6-2.8L (AFP) (1999)
-
Pry off black cover caps using screwdriver.
-
Loosen M8 hex nuts securing wiper arms, but do not remove completely.
-
Move wiper arms gently until they release.
-
Remove hex nut completely and remove wiper arms.
Cowl panel, removing
Tip: The cowl panel is clipped into a guide rail below the windshield.
-
Pull out rubber seal --1-- and unscrew bolts --2--.
-
Remove pollen filter cover.
-
Unclip trim on inner fender (arrows) on both sides.
-
Carefully pull cowl panel out upward.
Overlay harness, installing
-
Connect overlay harness to Transmission Vehicle Speed Sensor -G38-.
-
Route overlay harness along existing harness to plenum opening as shown -arrow-.White dotted line indicates general routing.