Jetta V6-2.8L (AFP) (1999)
-
Pry off black cover caps -arrows- using screwdriver.
-
Loosen M8 hex nuts securing wiper arms, but do not remove completely.
-
Move wiper arms gently until they release.
-
Remove hex nut completely and remove wiper arms.
Cowl panel, removing
Tip: The cowl panel is clipped into a guide rail below the windshield.
-
Pull out rubber seal -1- and unscrew bolts -2-.
-
Remove pollen filter cover.
-
Unclip trim on inner fender (arrows) on both sides.
-
Carefully pull cowl panel out upward.
Overlay harness, installing
-
Connect overlay harness to Vehicle Speed Sensor -G68-.
-
Route overlay harness along existing harness to plenum opening as shown -arrow- (illustration shows -G38- harness installed). White dotted line
indicates general routing.