Jetta V6-2.8L (AFP) (1999)
-
Route overlay harness in plenum along existing harness to Transmission Control Module (TCM) connector -arrow-.White dotted line indicates
general routing.
-
Disconnect multi-pin connector from TCM.
-
Cut tie wrap at end of connector and remove cover from connector by depressing tab with small screwdriver while pushing cover in direction of
-arrow-.
-
Obtain appropriate pin removal tool from VAS 1978 wire harness repair kit.
-
Locate cavity 66 of TCM connector (red wire) and remove terminal.
-
Insert the red wire of overlay harness into cavity 66.
-
Locate cavity 21 of TCM connector (green wire) and remove terminal.
-
Insert the green wire of overlay harness into cavity 21.
-
Locate cavity 44 of TCM connector (black wire) and remove terminal.
-
Insert the black wire of overlay harness into cavity 44.
-
Cut 3 wires (previously removed) as close as possible to the taped section of harness.
-
Install cover using new tie wrap.
-
Install multi-pin connector to TCM.
-
Tie wrap overlay harness to existing harness in plenum and engine compartment as necessary to ensure routing and prevent rattles.
Cowl Panel, installing
-
Installation is in reverse order of removal.