Jetta V6-2.8L (AFP) (1999)
-
Vehicles with engine code AFP, intake manifold lower part, disassembling and assembling,
-
Vehicles with engine code BDF, fuel distributor, disassembling and assembling.
-
Connect test box to control module wiring harness, connect test box for wiring test.
See: Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan
Tool/Test Box, Connecting For Wiring Test
Checking Proper Seal
-
Switch ignition on.
-
Bridge sockets 2 + 65 of test box with the respective adapter cables. Fuel Pump (FP) must run.
-
Check proper seal of fuel injectors (visual inspection). With Fuel Pump (FP) running, only 1 to 2 drops per minute should escape from each valve.
-
Disconnect connection between test box sockets.
-
Switch ignition off.
If fuel loss is greater:
-
Replace faulty fuel injector:
-
Vehicles with engine code AFP.
-
Vehicles with engine code BDF.
Note the following when installing the fuel injectors:
-
Replace O-rings on all fuel injectors and wet them slightly with clean motor oil.
-
Insert fuel injectors into fuel rail perpendicular and in the right position, and secure them with retaining clips.
-
Position fuel distributor with secured fuel injectors and apply uniform pressure to press it in.
-
The connectors must audibly engage on valves when attached.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4:
Reset/Erase Diagnostic Data
-
Generate readiness code.
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Checking Injection Quantity
-
Insert a fuel injector to be tested into a measuring glass of VAG1602 tester for fuel injection quantity.
-
Using respective adapter cables, connect one terminal of fuel injector to be checked to engine Ground (GND).
-
Use adapter cable to connect second terminal of fuel injector to VAG1348/3 remote control with VAG1348/3-2 adapter cable.
-
Connect alligator clip to B+.
-
Switch ignition on.
-
Bridge sockets 62 + 65 of test box with the respective adapter cables. Fuel Pump (FP) must run.
-
Operate VAG1348/3 remote control for 30 seconds.
-
Repeat test on other fuel injectors. Use new graduated measuring glasses for this.
NOTE: Also check spray pattern when checking injection quantity. Spray pattern must be the same for all injectors
-
After all fuel injectors have been activated, place graduated measuring glasses on a level surface and compare quantity of injected fuel. Specified
value: 110 to 130 ml per injector
-
Disconnect connection between test box sockets.
-
Switch ignition off.
If the measured value of one or more fuel injectors is below or above the indicated specified value:
-
Replace faulty fuel injector:
-
Vehicles with engine code AFP, item 12,