Jetta V6-2.8L (AFP) (1999)
Clutch Release Bearing: Service and Repair
5 Speed Manual 02J
Clutch Release Mechanism, Servicing
1. Transmission
2. Ball stud, 25 Nm (18 ft. lbs.)
-
Lubricate with MOS2 grease
3. Input shaft oil seal
-
Replacing refer to Manual Transmission/Transaxle; Input Shaft.
4. Guide sleeve
-
With vulcanized C-ring
-
If damaged replace guide sleeve and O-ring together
-
Lubricate guide sleeve in area of release bearing with MOS2 grease
5. Retaining spring
-
Secure to clutch release lever
6. Securing bolt, 20 Nm (15 ft. lbs.)
7. Clutch release lever
8. Release bearing
-
Do not wash with solvents, only wipe off
-
Replace noisy bearings
-
Lubricate surfaces which contact release lever with MOS2 grease
9. Bolt, 20 Nm (15 ft. lbs.)
10. Slave cylinder
-
Removing and installing. Refer to Clutch Master Cylinder.
11. Plunger
-
Grease end of plunger with MOS2 grease
12. Assembly bolt
-
Secures the clutch release lever when installing transmission
-
Remove after transmission has been installed
Note:
-
If the assembly bolt (item -12-) is not available, an M8 x 35 bolt can be used.