Jetta V6-2.8L (BDF) (2002)
Removing
-
Remove engine cover.
-
Remove center and right insulation trays
-
Remove ribbed belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair
-
Pull off crankcase breather connecting hose between cylinder head cover and intake hose on cylinder head cover.
Note:
Press buttons on hose couplings to disconnect
-
Drain coolant See: Cooling System/Service and Repair
-
Install engine support bracket 10-222A with legs 10-222A/1.
-
Insert securing hook of supporting device in right lifting eye of cylinder block and put engine under slight tension.
-
Unbolt engine side of assembly mounting from top of engine bracket -arrows-.
Note:
Use ladder VAS 5085 to remove securing bolts.
-
Lower engine on supporting device only as far as necessary to remove coolant pump.
-
Remove belt pulley. Counter-support belt pulley with water pump wrench VAG 1590 when doing this.
Note:
If engine has been removed, it is not necessary to remove belt pulley. The coolant pump securing bolts can be unscrewed through the holes
in the pulley.