Jetta V6-2.8L (BDF) (2002)
/Page-365001.png)
Alignment: Testing and Inspection
Test Requirements:
Test requirements:
^
Check suspension, wheel bearing, steering and steering linkage for excessive play and damage.
^
Tire tread depth difference no more than 2 mm (0.079) on an axle.
^
Tires inflated to correct pressure
^
Vehicle aligned, suspension bounced and rocked several times
^
Vehicle unladen (curb weight)
Fuel tank must be full
Spare wheel and vehicle tools are stowed at correct installing locations
The fluid reservoir for the windshield/headlight washer system must be full.
^
Make sure that the sliding plates and turntables (alignment equip.) are not touching an end stop when checking the wheel alignment.
^
Do not check vehicle alignment before vehicle has completed 1000 to 2000 km (600 to 1200 miles), to allow coils springs to settle.
Please note!
^
The test equipment must be properly adjusted and attached to the vehicle; observe device manufacturer's operating instructions.
Adhere to manufacturer of your vehicle alignment equipment for training as required.
Vehicle alignment platforms and vehicle alignment units/vehicle alignment computers can lose their calibration over a period of time.
Vehicle alignment platforms and vehicle alignment units/vehicle alignment computers should be checked and if necessary adjusted within the
framework of an inspection/maintenance at least once a year!
-
Treat these highly sensitive units carefully and conscientiously!
