Jetta V6-2.8L (BDF) (2002)
/Page-1011002.png)
^
Check for secure seating
14. Fuel tank
15. Clamping washer
16. Heat shield
^
For fuel tank
17. 25 Nm
18. Clamping nut, 2 Nm
19. Fuel tank cover
20. Securing strap
^
Note differing lengths
^
Installation position: Fixing point (holes) point in direction of travel (forward)
21. Supply line
^
Black
^
Check for secure seating
^
To pull off of fuel filter press release buttons on connecting piece
22. Fuel filter
^
Installation position: Arrow points in direction of flow
23. Screw-type clip
^
Observe installation position
24. Breather line
^
White
^
Check for secure seating
^
Clipped onto side of fuel tank
^
To EVAP canister purge regulator valve -N80
25. Seal
^
Replace if damaged
^
When installing, insert seal dry into fuel tank opening
^
Moisten with fuel only when installing fuel delivery unit flange
26. Fuel delivery unit
^
Observe installation position of flange on fuel tank, Refer to Fig. 1
28. Supply line
^
Black
^
Check for secure seating
^
Clipped onto side of fuel tank
^
When puling off flange and fuel filter press release button on connecting piece
29. Return line
^
Blue or with blue marking
^
Clipped onto side of fuel tank
^
Check for secure seating
^
To remove from flange press release button on connecting piece
^
From fuel return pipe on fuel rail
30. Connector
^
Black, 4-pin
^
For Fuel gauge sender -G- and Fuel Pump (FP) -G6
31. 10 Nm
Fig. 1 Installation position of fuel delivery unit flange
Marking on sender must align with marking on fuel tank -arrows-.
Blue or blue marked return line -1- to union with identification -R-.
Black supply line -2- to union with identification -V-.
Note: After installing fuel delivery unit flange, check that the supply, return and breather lines are still clipped onto the fuel tank.
