Jetta V6-2.8L (BDF) (2002)
/Page-1102001.png)
Control Module: Service and Repair
Removing control module
-
Switch ignition off, open hood.
-
Remove wiper arms and cowl panel:
-
Release multi-pin connector, then disconnect connector from control module.
-
Remove screws -arrows-.
-
Remove control module.
Installing control module
Installation is performed in the reverse order of removal.
-
Locate multi-pin connector on control module -J217- pins (arrows) then lock multi-pin connector.
-
Perform On Board Diagnostic (OBD).
