volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Molded Headliner, Removing and Installing (Vehicles With Sunroof)|Page 8607 > < Glove Compartment Lock Cylinder|Service and Repair|Page 8602
Page 1
background image

Headliner: Service and Repair
Molded Headliner, Removing and Installing (Vehicles With Sunroof)

Molded Headliner, Removing And Installing (Vehicles With Sunroof)

NOTE:

-

Slight changes may have to be made to removal and installation procedures, depending upon equipment installed in vehicle.

-

Before disconnecting battery, see note in Owners Manual concerning radio.

-

Obtain radio anti-ft code before disconnecting battery.

Removing

CAUTION:  Disconnect battery ground (GND) strap before working on electrical system.

-

Switch ignition off.

-

Remove upper A pillar trim:
-

with side curtain protection.

-

without side curtain protection.

-

Remove upper B-pillar trim:
-

with Side curtain protection --> 04.01.

-

with Side curtain protection 05.01 -->.

-

without Side curtain protection.

-

Remove roof end strip:
-

Golf.

-

Golf wagon/Jetta wagon.

-

Loosen upper C-pillar trim:
-

Golf with Side curtain protection .

-

Golf without Side curtain protection.

-

Jetta with Side curtain protection.

-

Jetta without Side curtain protection.

-

Golf wagon/Jetta wagon with Side curtain protection --> 04.01.

-

Golf wagon/Jetta wagon with Side curtain protection 05.01 -->.

-

Golf wagon/Jetta wagon without Side curtain protection.

-

Remove upper D-pillar trim (Golf wagon/Jetta Wagon): Upper D-pillar trim, removing and installing (Golf wagon/Jetta wagon).

-

Remove sun visor.

-

Remove center sun visor.

-

Remove grab handle (roof).

-

Remove door inner seals at top.

-

Unclip trim - 1 - in direction of - arrow - and remove.

Molded Headliner, Removing and Installing (Vehicles With Sunroof)|Page 8607 > < Glove Compartment Lock Cylinder|Service and Repair|Page 8602