Jetta GL L4-1.9L DSL Turbo (ALH) (2001)
/Page-1396011.png)
^
Turn ignition switch to "ON" position
^
On the VAS 5051 Start-Up screen, press "Vehicle Self Diagnosis" button
^
Select "03 - Brake Electronics"
^
Select "07 - Code control unit"
<-- Enter relevant code number for this vehicle when installing ABS control module 1C0 907 375 J
^
Press the "Q" button to confirm
Note:
On the display, in the upper right corner, the control module part number and coding are displayed
^
Press <-- button
^
Select "06 - End output"
^
Disconnect VAS 5051 from vehicle
^
Recode radio and reset radio preset stations
^
Reset clock
^
Where applicable, reset power window pinch protection
^
Turn ignition to "OFF" position
^
Proceed to Section E
Section E
Section E - Brake Bleeding
^
Connect brake charge and bleed unit US 1116 or VAS 5234 to vehicle
IMPORTANT:
When at least one chamber in the brake fluid reservoir is completely empty (e.g. leaks in braking system) the hydraulic unit must be bled with
scan tool VAS 5051 or V.A.G. 1551 in function "basic setting".
WARNING!
Make sure that a filling pressure of 1 bar (14.5 psi.) is not exceeded, when filling brake fluid using brake filling and bleeding unit VAS 5234 or US
1116
Note:
