volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Manufacturer's Scan Tool|Page 3726 > < Manufacturer's Scan Tool
Page 2
background image

-

Connect multimeter using jumper wire from VAG test kit between terminal 1 and engine Ground (GND). 

-

Switch ignition ON.
^

Specification: at least 11.5 V 

If the specification was not obtained:
-

Switch ignition off.

-

Remove windshield wiper arms and plenum cover.

-

Connect VAG 1598/22 Test Box to harness connector of control module.

-

Check wiring for short circuit between Test Box sockets.

Manufacturer's Scan Tool|Page 3726 > < Manufacturer's Scan Tool