Jetta GL L4-1.9L DSL Turbo (ALH) (2001)
-
Unscrew two bolts -arrows B-.
-
Carefully slide cover with protective sleeve to front over selector lever cable.
Note: Be careful not to damage protective sleeve.
-
Pry selector lever cable -3- off selector lever -2 with a screwdriver.
-
Pull out selector lever cable locking plate -1- on mounting bracket downward.
-
Pull selector lever cable carefully out of mounting bracket.
Installing
-
Check the protective sleeve for damage; the protective sleeve can only be changed together with the selector lever cable.
-
Check that the protective sleeve is correctly tiffed. Do not install the protective sleeve twisted.
-
Do not bend or kink the selector lever cable.
-
Selector lever and lever/selector shaft are in "P" position, the front wheels are blocked.
-
Insert selector lever cable -3- in mounting bracket and press onto selector lever -2-.
-
Fit new selector lever cable locking plate -1- on mounting bracket.
Installation position:
Angled end of locking plate must point toward end of selector lever cable.
-
Shift selector lever from "P" to "2".
-
Selector lever mechanism and selector lever cable must move freely. If necessary replace selector lever cable or service selector lever
mechanism.
-
Shift selector lever into "P" position.
-
Tighten cover with bonded seal to mounting bracket.
Note: Ensure the seal remains seated correctly.