Jetta GL L4-1.9L DSL Turbo (ALH) (2001)
/Page-1290003.png)
-
Turn right-angled piece -A- back to original position (direction of arrow).
-
The selector shaft must now be able to be moved (in direction of arrow).
-
Pull pin T10027 out of holes -A- and -B-.
-
Clip boot into frame.
Functional check
-
The gear shift lever must rest in the 3rd/4th gear gate with the transmission in neutral.
-
Operate clutch.
-
Select all gears several times. Pay particular attention to operation of reverse gear lock.
Should a gear fail to engage smoothly after repeated selection, the selector shaft play (lift) should be checked as follows:
-
Engage 1st gear.
-
Press gear lever to left onto stop and release while observing selector shaft in transmission (2nd mechanic).
