Jetta GL Wagon L4-1.9L DSL Turbo (ALH) (2002)
Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Vehicles with 80-pin control module and autom. transmission
-
Remove wiper arms and wind cowl:
-
Disconnect connector (arrow) from Transmission Control Module (TCM).
-
Connect V.A.G 1598/18 Adapter - 68-pin to wiring harness of Transmission Control Module (TCM) -1- and engage the connector -2-.
-
Check CAN-Bus wires with terminal resistances in ECM and ABS control module:
-
To do this, measure resistance between test box sockets 3 +25:
Specified value: 55...75 Ohm
If resistance value is not in specified range:
-
Continue test according to the following table: