Jetta GLS L4-1.8L Turbo (AWD) (2001)
/Page-526002.png)
5. Thrust washer
^
For bearing cap 3
^
Note positioning
6. Sensor wheel
^
For Engine Speed (RPM) sensor -G28
^
Installation possible in one position only, hole is offset
7. 10 Nm (7 ft. lbs.) + additional 1/4 turn (90°)
^
Always replace
^
Torque angle can be measured with Hazet 6690 torque angle meter or equivalent.
8. Dowel pin
^
Checking projection from crankshaft see Fig. 1
9. Crankshaft
^
Axial clearance
New: 0.07 to 0.17 mm
Wear limit: 0.37 mm
^
Check radial clearance with Plastigage:
New: 0.03 to 0.08 mm
Wear limit: 0.17 mm
^
Do not rotate crankshaft when checking radial clearance
^
Crankshaft dimensions
10. Thrust washer
^
For engine block, bearing 3
Fig. 1 Crankshaft dowel pin projection, checking
Special tools
^
Depth gauge
-
Check projection of dowel pin with drive sensor plate -1- removed.
1. Sensor plate
2. Securing bolt
3. Projection of dowel pin -3- from crankshaft
a = 2.5 to 3.0 mm
