Jetta GLS L4-1.8L Turbo (AWD) (2001)
-
Loosen knurled screw and turn inner part of extractor against camshaft until oil seal has been extracted.
Installing
Note: Gradual introduction of PTFE oil seal (identifying characteristics: no annular spring, sealing lip wider). The sealing lip of this oil ring must
not be oiled or lubricated. A plain encased seal of older construction (with annular spring) may be replaced with a PTFE oil seal, but not vice
versa.
-
Before installing, remove oil remains from camshaft journal with a clean cloth.
-
Fit assembly tool T10071/1 onto camshaft journal.
-
Slide oil seal over assembly tool onto camshaft journal.
-
Press seal in onto stop with press sleeve T10071/3 and bolt T10071/4.
The rest of the assembly is basically a reverse of the disassembling sequence.
When installing toothed belt and adjusting timing.