Jetta GLS L4-1.8L Turbo (AWD) (2001)
^
3365 Valve stem seal driver
Removing
-
Remove camshafts.
-
Remove the valve lifters and place them with the contact surface downwards. When doing this make sure that the tappets are not interchanged.
-
Remove spark plugs with spark plug spanner 3122B.
-
Set piston of appropriate cylinder to "bottom dead center".
-
Screw pressure hose VW 653/3 into the spark plug thread.
-
Insert thrust piece 3362/1 in valve spring depressor 3362.
-
Mount valve spring depressor 3362 with securing bolts screwed in on cylinder head.
-
Position installation tool for compressing valve springs to one of the following positions outer intake valves: lower position, center intake valve:
upper position, exhaust valve: lower position
-
Connect pressure hose to compressed air system supplying at least 6 bar and remove valve springs.