Jetta GLS L4-1.8L Turbo (AWD) (2001)
-
Bring mark on camshaft in line with the mark on cylinder head cover.
-
Turn crankshaft to TDC No. 1 cylinder.
-
Install toothed belt onto camshaft sprocket.
-
Tension toothed belt.
Tensioning toothed belt
-
Tension toothed belt by pulling out locking pin T40011 and removing tensioning bolt T10092.
-
Turn crankshaft two full turns and check whether camshaft and crankshaft marks align with their reference points.
-
Install vibration damper/belt pulley tightening torque: 25 Nm
-
Install center part of toothed belt guard. (Insert securing bolts with locking fluid "D 000 600 A2".) Tightening torque: 10 Nm
-
Install upper toothed belt guard.
-
Install engine assembly mount, refer to Engine - Drive Belts, Mounts, Brackets and Accessories - Engine Mount - Service and Repair -
Procedures See: Drive Belts, Mounts, Brackets and Accessories/Engine Mount/Service and Repair
-
Install ribbed belt tensioner. Tightening torque: 25 Nm
-
Install ribbed belt, refer to Engine - Drive Belts, Mounts, Brackets and Accessories - Drive Belt - Service and Repair - Procedures See:
Drive Belts, Mounts, Brackets and Accessories/Ribbed Belt/Service and Repair/Procedures