volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Water Pump|Specifications|Page 2295 > < Water Pump|Specifications|Page 2293
Page 2
background image

-

Connect contacts of after-run coolant pump (V51) to battery using aux. cables from V.A.G 1594. After-run coolant pump must run.

If the after-run coolant pump does not run:
-

Replace after-run coolant pump (V51).

If the after-run coolant pump (V51) runs:
-

Switch ignition off and on again.

-

Connect VAG 1527B voltage tester to disconnected connector for after-run coolant pump (V51) with auxiliary cable from V.A.G 1594 A LED
must light up.

Note:  This check must be performed within minutes after switching ignition off.

If the LED does not light up:
-

Locate and repair open circuit using wiring diagram.

Water Pump|Specifications|Page 2295 > < Water Pump|Specifications|Page 2293