Jetta GLS L4-1.8L Turbo (AWD) (2001)
/Page-2519004.png)
^
If there is no ESP or ASR switch and only a blank cover -2-, apply adhesive tape to instrument panel under cover, use a flat screw driver -A- to
remove cover.
^
Insert assembly tool T10034 into opening, release clip holding emergency light switch -3- and pull it out of instrument panel.
^
Disconnect connector from emergency light switch.
^
On new emergency light switch (1J0 953 235 J 01C) reconnect connector and install switch into instrument panel.
^
Reinstall blank cover and remove adhesive tape.
^
Check turn signal and emergency light switch for correct operation.
^
Check all turn signal and emergency light switch bulbs for illumination and replace as required.
^
Destroy and properly dispose of removed part(s).
Section B - Emergency Light Switch Replacement on Vehicles with ESP or ASR
