Jetta GLS L4-1.8L Turbo (AWD) (2001)
Engine overlay harness, preparation (2002 automatic transmission vehicles only)
Prior to installing the engine overlay harness, prepare the harness as follows:
^
Speed sensor wiring will not be used.
-
Cut speed sensor wiring approx. 4Omm from breakout -A- and tape back to harness using method as described in "Unused wiring, terminating".
-
Cut pins 2 and 3 of short harness for 14 pin connector breakout -B- and tape back to harness using method as described in "Unused wiring,
terminating"..
Ignition coil harness, removing
-
Obtain radio code and preset radio stations.
-
Disconnect battery ground (GND) strap.
-
Remove air cleaner housing (see Repair Manual Group 24).
-
Remove battery and battery tray (see Repair Manual Group 27).
-
Remove engine wiring harness covers.
-
Remove upper engine cover.
-
Remove air cleaner air duct to left fender.