Jetta GLS L4-1.8L Turbo (AWP) (2002)
Indicated on display: (1 to 4 = display zones)
Basic setting 60
->
xxx%
xxx% 8
ADP.OK.
Adapting has been performed successfully.
-
End engine basic setting by pressing -> key.
-
Press keys 0 and 6 for function "End output" and confirm entry with Q key.
To store the values:
-
Switch ignition off.
NOTE:
If the basic setting of the control module is interrupted, the cause could be one of the following:
-
The test conditions were not fulfilled.
-
Throttle valve control module or wiring is faulty. Check. See: Testing and Inspection
After an interruption a code is stored in DTC memory. When next switching on ignition the basic setting is automatically performed again.