Jetta GLS L4-1.8L Turbo (AWP) (2002)
-
Remove shelf on driver's side:
-
Pull connector off clutch pedal switch.
-
Connect multimeter to measure resistance between contacts of connector.
Specification: approx. 0 Ohm
-
Depress clutch pedal.
Specification: infinity Ohm (no continuity)
If the specification is not attained:
-
Replace clutch pedal switch.
NOTE: Observe installation position of clutch pedal switch in bearing bracket upper assembly hole.
-
Check DTC Memory, if necessary, repair any malfunctions and then Erase DTC Memory, Checking and Erasing DTC Memory. Refer to
"Displaying and Reading Trouble Codes/With Manufacture Scan Tool/Check DTC Memory (Function 02)" See: Computers and Control
Systems/Testing and Inspection
-
Read readiness code. If DTC memory has been erased or engine control module was disconnected from permanent positive, readiness code must
be generated again: Refer to "Monitors, Trips and/or Drive Cycle/ Reading Readiness Code" See: Computers and Control Systems/Testing and
Inspection
Engine code AWP, Refer to "Monitors, Trips and/or Drive Cycle/Generating Readiness Code" See: Computers and Control Systems/Testing and
Inspection
If the specification is obtained:
-
Connect multimeter using aux. cables from V.A.G 1594 to measure voltage between contact 2 and Ground.
-
Switch ignition on.
Specification: At least 11.5 V
If the specification is not attained: