Jetta GLS L4-1.9L DSL Turbo (ALH) (2001)
Front Door Panel: Service and Repair
Drivers Side Front Door Trim, Removing and Installing
Drivers Side Front Door Trim, Removing And Installing
NOTE:
-
Since partition is very narrow, use a sharp screwdriver to prevent damage to panel and grip recess.
-
Obtain radio unit code before disconnecting battery.
-
Do not grasp in grip depression when pulling off grip recess as a strut secured to door trim is underneath.
-
Removing and installing driver side front door trim for vehicles with manual window regulators is same as removing and installing Passengers side
front door trim
Removing
CAUTION: Disconnect battery ground (GND) strap before working on electrical system.
-
Switch ignition off.
-
Insert flat screwdriver in lower partition between panel - 1 - and grip recess - 2 -.
-
Unclip grip recess - 2 - upward out of door trim, do not reach into grip depression while doing so, to prevent damage to brace - 1 -.
-
Press locking lug against connector - 3 - - arrow - and remove.
-
Remove screws - arrows -.
-
Unclip door trim - 1 - at sides using Disassembly pliers 3392.
-
Lift door trim upward out of window recess.