Jetta GLS L4-1.9L DSL Turbo (ALH) (2001)
^
Remove three foam washers from assembly.
^
Unfold cables, tie wraps (arrows) through center of assembly are removed later in procedure).
Tip: Orientation of tie wraps should be such that the locking block of the tie wrap does not interfere with installation of regulator to the carrier
assembly.
Regulator/cable assembly, installing
Tip: Slide long cable (from regulator) under single cable (already installed).
^
Attach regulator to carrier by inserting three pins from regulator into the carrier assembly (pressing gently to seat).
^
Slide cable sheathing ends into regulator (arrows).
^
Insert short cable (from regulator assembly) into carrier assembly nearest speaker hole (black arrow), leaving cable loose (as shown) DO NOT
route cable around this pulley at this time.
^
Insert long cable into carrier assembly opposite speaker hole (white arrow), routing cable around pulley (use correct tool as necessary).
Tip:
Cable ends must end up near top of regulator for insertion into A-pillar clamp (clamp nearest speaker).
A-pillar clamp is always installed first and can only be installed at top of carrier. With regulator/cable assembly installed onto carrier
With regulator/cable assembly installed onto carrier assembly:
^
Locate new clamps, remove isolators and set isolators aside for installation later in this procedure.
^
Install new clamps, see "Window clamp, installing on track."