Jetta GLS L4-1.9L DSL Turbo (ALH) (2001)
-
Remove securing nuts -arrows-.
-
Lift engine cover -A- from engine.
-
Remove charge air pipe between charge air cooler and exhaust turbocharger.
-
Mark direction of rotation of ribbed belt if it is to be reused.
-
Swing tensioning roller in direction of arrow using open law spanner 16 mm A/F on tensioning lever.
-
Remove ribbed belt.
NOTE: Take ribbed belt off idler roller first
Ribbed belt, installing
NOTE:
-
When installing used ribbed belts observe the direction of rotation marked on removal!
-
Ensure, before installing ribbed belt, that all ancillaries (generator air conditioner compressor PAS vane pump) are secured tightly.
-
On vehicles with air conditioner remove ribbed belt from idler roller first and fit on idler roller last when installing.
-
When fitting the belt ensure the ribbed belt locates correctly in the pulleys!
-
Swing tensioning roller in direction of arrow using 16 mm open-end wrench on tensioning lever.
-
Fit ribbed belt.