Jetta GLS L4-1.9L DSL Turbo (ALH) (2001)
/Page-424009.png)
Note:
-
In case the eccentric was turned past the marks, the tension roller must be completely relieved of tension, and then be tensioned again. If turned
too far, the eccentric must not just be turned back again to the passed mark.
-
Tighten clamping nut on tensioning roller. Torque specification: 20 Nm.
Note:
-
Make sure the tensioning roller is properly positioned in the rear toothed belt guard - arrow -.
-
Verify TDC marking on flywheel once again.
-
Tighten bolt for camshaft sprocket to 45 Nm.
