Jetta GLS L4-1.9L DSL Turbo (ALH) (2001)
-
Pull cover -1- off in direction of arrow.
-
With ignition switched off, connect tester VAS 5051 to diagnostic connection using cable VAS 5051/3.
-
Switch tester on.
The tester requires approx. 5 minutes to warm up.
-
Switch ignition on.
-
Select mode of operation: press button on touch screen for "Vehicle self-diagnosis".
-
Select vehicle system: select "02 - gearbox electronics" on touch screen.
-
Select diagnostic function: at this point, all diagnostic functions are available.
-
Select "08 - read measured value blocks" on touch screen.
-
Press button on touch screen for" basic settings" and continue to display zone for ATF temperature.
Test procedures available on the V.A.G. 1551 are described below.
-
Connect V.A.G 1551 Scan Tool and enter address word "02 Transmission electronics" and advance until "Select function XX" is indicated on
display.
Indicated on display
-
Press keys O and 8 (The function "Read measured value block" is selected with 08).
Indicated on display
-
Confirm entry with key Q.
Indicated on display
-
Press keys O and 2 (002 selects "Display group number 002").
-
Confirm entry with Q key.
Indicated on display
The third display zone shows the ATF temperature.
Note: The ATF temperature must not be more than approx. 30°C at start of test.
-
Start engine.
-
Raise vehicle.