Jetta GLS L4-1.9L DSL Turbo (ALH) (2001)
-
Place drip tray under transmission.
-
Bring ATF to test temperature.
Test temperature: 35°C to 45°C
-
Remove ATF inspection plug from transmission housing (arrow).
At first the ATF present in the overflow pipe (arrow 2) will run out.
-
Observe amount of ATF draining from plug hole afterward.
If ATF continues to drip out of hole:
ATF need not be topped up.
-
Install new seal (arrow 1) to ATF inspection plug and tighten to 15 Nm. ATF check is completed.
-
End output with V.A.G 1551. See below.
If the ATF present in the overflow pipe runs out of the plug hole but no further draining is observed:
-
Top up ATF in transmission.
ATF, Topping Up
With engine running.
WARNING:
-
When working in the vicinity of the radiator, always maintain a safe working distance - Danger of injury!
-
Fan could start automatically.