Jetta GLS L4-1.9L DSL Turbo (ALH) (2001)
-
Fitted on front tunnel heat shield
8. Locking plate
-
Secures selector lever cable to mounting bracket
-
Always replace
9. Selector lever cable
-
Do not bend or kink
-
If outer cable is damaged the selector lever cable must be replaced
-
Checking and adjusting
-
Removing and installing
-
Do not grease cable eye and ball socket
10. Collared nut, 10 Nm.
-
For cover to mounting bracket
-
Qty. 4
-
Self-locking
-
Always replace
11. Cover
-
For mounting bracket
-
With bonded seal
12. Hex bolt
13. Locking pawl
-
For selector lever lock
-
Grips into cable lever of mounting bracket
14. Shift lock solenoid -N110
-
Can be replaced with selector mechanism installed
-
Removing and installing
-
Can be checked in electrical test and in measured value block
15. Mounting bracket
-
Removing and installing
16. Locking cable
-
For ignition key removal lock
-
Must not be kinked
-
Removing and installing
-
Adjusting
-
Checking operation of the ignition key withdrawal lock.
17. Steering lock
18. Clip
-
Position: push on clip from above. The angled ends of clip face steering lock.
Selector Lever Handle Removing and Installing
Removing and installing selector lever handle
Removing
-
Shift selector lever to position "R".