Jetta GLS V6-2.8L (AFP) (2002)
-
Disconnect 5-pin harness connector from Mass Air Flow (MAF) sensor -G70- with Intake Air Temperature (IAT) sensor -G42- (arrow).
-
Bridge harness connector terminals -1- + - 3- using auxiliary cables from VW1594 and observe display.
If display jumps to approx. 140 °C:
-
Press -> button.
-
Press buttons -0- and -6- to select "End Output" function 06 and press -Q- button to confirm input.
-
Switch ignition off.
-
Replace Mass Air Flow (MAF) sensor - G70-, item -4-. Refer under "Fuel Delivery and Air Induction/Fuel Injector", See: Powertrain
Management/Fuel Delivery and Air Induction/Service and Repair
-
Check DTC memory. If necessary, repair any malfunctions and erase DTC memory.
-
Display readiness code.
If DTC memory has been erased or the Engine Control Module (ECM) was disconnected from permanent battery (B+) voltage, the readiness code
must be generated again.
If display remains at approx. -40.0 °C:
-
Press -> button.
-
Press buttons -0- and -6- to select "End Output" function 06 and press -Q- button to confirm input.
-
Switch ignition off.
-
Check wiring according to wiring diagram.
Continuation of check when display reads approx. 140 °C: