Jetta GLS V6-2.8L (AFP) (2002)
Varying tolerances make it possible to obtain the exact shim thickness required.
^
Press in tapered roller bearing outer race together with determined shim (in Example 1.65 mm) while supporting transmission housing with thrust
piece 2050 directly under bearing support.
Perform check measurement
^
Determined shim installed.
^
Install measuring tools. Put washers with a total thickness of 8 mm on bolt -arrow- securing installation tool VW 792 to clutch housing.
^
Set dial gauge (3 mm measuring range) to zero with 1 mm preload.
^
Loosen clutch housing/transmission housing securing bolts diagonally until output shaft moves freely in transmission.
^
If correct shim has been selected, dial gauge will indicate a value of 0.15 mm to 0.25 mm.