Jetta GLS VR6 V6-2.8L (AFP) (2001)
/Page-624002.png)
-
Set and check position of crankshaft in relation to intermediate shaft.
The ground tooth of drive gear -13- must be aligned with the bearing parting line (TDC cyl. 1).
-
Install bolt without collar for sliding rail -2- and tighten to 10 Nm.
-
Install sliding rail -2- with roller chain -1- and both sprockets -3- and -4- (note direction of travel of roller chain.
The mark on the sprocket for roller chain -4- must be aligned with notches -C- or -D- on the thrust washer.
-
Release stop teeth in chain tensioner with a small screwdriver -A-.
-
Press tension bar against chain tensioner and tighten chain tensioner to 10 Nm.
