Jetta GLS VR6 V6-2.8L (AFP) (2001)
-
The respective fuses of Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130- must be OK.
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers like, for example, lights and rear window heating must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
For vehicles with automatic transmission, selector lever must be in position -P- or -N-.
-
If vehicle is equipped with an A/C system, it must be switched off.
-
Ground (GND) connections between engine and chassis must be OK.
-
Exhaust system must be properly sealed between catalytic converter and cylinder head.
-
Coolant temperature must be at least 80 degree C, Diagnostic mode 1: Check measuring values; PID 5, Coolant temperature.
See: Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 1: Check Measured Values
-
Oxygen sensor heater for oxygen sensor behind catalytic converter must be OK.
See: Testing and Inspection/Component Tests and General Diagnostics/Oxygen Sensor Heater For O2 Sensor After TWC, Checking
Function test
-
Select the output of oxygen sensor signals and check whether the specified values are being reached, Diagnostic mode 5: Check output of oxygen
sensor signals.
See: Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 5: Check Output of Oxygen Sensor Signals
If specified values are obtained:
-
End diagnosis and switch ignition off.
If specified values are not obtained:
-
End diagnosis and let engine continue to run at idle.
-
Check primary voltage.
Checking primary voltage
-
Unscrew protective cover (arrows) and disconnect 4-pin harness connector (black) -1- to Oxygen Sensor (O2S) Behind Three Way Catalytic
Converter (TWC) -G130-.