volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Power Supply and Cables Check|Page 3480 > < Power Supply and Cables Check|Page 3478
Page 2
background image

-

Slowly depress accelerator pedal up to Wide Open Throttle (WOT) stop while observing the percentage display.

The percentage display must increase uniformly.

-

Check specified value of throttle valve position (absolute) at Wide Open Throttle (WOT) stop:

-

End diagnosis and switch ignition off.

If specified values are not obtained:

-

Disconnect the 6-pin connector at the throttle valve control module (arrow).

Check resistance

-

Measure resistance of Throttle drive (power accelerator actuation) -G186- in Throttle Valve Control Module -J338- between terminals 3 + 5
Specified value: 1.0...5.0 Ohm

If specified value is not obtained:

-

Replace Throttle Valve Control Module -J338-:

Power Supply and Cables Check|Page 3480 > < Power Supply and Cables Check|Page 3478