Jetta GLS VR6 V6-2.8L (AFP) (2001)
Transmission Position Switch/Sensor: Testing and Inspection
Vehicles with automatic transmission only
The engine control module receives the following information from the transmission control module:
-
Driving range selected (selector lever in 1/2/3/R/D) or
-
No driving range selected (selector lever in P or N)
Special tools and equipment
-
VAG1551 Scan Tool (ST) or VAG1552 mobile scan tool with VAG1551/3 adapter cable
-
VAG1598/31 test box
-
Multimeter (Fluke 83 or equivalent)
-
VW1594 adapter set
-
Wiring diagram
Test conditions
-
Automatic transmission selector lever in "P" or "N" position
-
Air conditioner switched off
Test sequence
-
Connect VAG1551 (VAG1552) Scan Tool (ST). Refer to "On Board Diagnostic (OBD)/VAG1551 Scan Tool (ST), Connecting and Selecting
Functions" under "Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector", See: Powertrain Management/Fuel Delivery and Air
Induction/Fuel Injector/Testing and Inspection
-
Switch ignition on and press buttons -0- and -1- to insert "Engine Electronics" address word 01.
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -8- to select "Read Measuring Value Block" function 08 and press -Q- button to confirm input.
Indicated on display
Read Measuring Value Block
Input display group number XXX
-
Press buttons -0-, -5- and -1- to in put display group number 51(051) and press -Q- button to confirm input.
Indicated on display: (1-4 = display fields)
Read Measuring Value Block 51
->
1
2
3
4
-
Check specified values in display field 3: