Jetta GLS VR6 V6-2.8L (AFP) (2001)
-
Move selector shaft with detent segment -1 in position "2".
-
Insert new O-rings -arrows- in transmission housing.
Note: Ensure that O-rings remain seated correctly when installing valve body.
-
Install valve body so that pin of detent segment engages in groove of manual valve -1-.
Only the end of the manual valve is visible. The groove on the valve cannot be seen.
-
Check operation of manual valve.
-
Tighten valve body bolts (arrows) by hand.
-
Tighten bolts to 8 Nm working from inside outward.
-
Clip transmission sensor wiring harness -3- into retaining tabs -4- installed for this purpose.
-
Join connectors -1- and -2-.