Jetta GLS Wagon L4-1.8L Turbo (AWP) (2002)
Rear Bumper Cover / Fascia: Service and Repair
Rear Bumper Cover, Assembly Overview
Rear Bumper Cover, Assembly Overview
NOTE: Slight changes may have to be made to removal and installation procedures, depending upon equipment installed in vehicle.
1
-
Rear bumper cover
-
Material - PP/EPDM
2
-
Guide piece
-
To remove and install, pull out/slide in bumper cover parallel out of guide pieces (left and right sides)
3
-
Bolt
-
Qty. 8 (for common models Golf/Jetta)
-
Qty. 10 (for Jetta GLI Sport)
-
1.5 Nm
4
-
Mounting strip
5
-
Bolt
-
Qty. 4
-
6.6 Nm
6
-
Impact strip
-
For common models Golf/Jetta: clipped in cover
-
For Jetta GLI Sport: delivered as by-pack
-
It is not necessary to remove when removing cover.
7
-
Bolt
-
6.6 Nm
-
Only on Jetta models