Jetta GLS Wagon L4-1.8L Turbo (AWP) (2002)
/Page-739003.png)
Engine code AWP, Refer to "Monitors, Trips and/or Drive Cycle/Generating Readiness Code" See: Computers and Control Systems/Testing and
Inspection
If oxygen sensor heating has continuity:
-
Set multimeter to measure voltage and connect to contact 3 (connector to engine control module) and Ground (GND).
-
Start engine and run at idling speed.
-
Measure voltage supply:
Specification: 11.0 to 14.5V
If the specification is not obtained:
-
Check wiring from contact 3 to fuel pump relay (J17) using wiring diagram.
If the specification is obtained:
-
Connect multimeter using aux. cables from VAG1594 to measure voltage at contacts 3 and 4 (connector to engine control module).
-
Check activation by engine control module while observing display group 41, display zone 2.
Display Htg.bC.ON
Specification: 11.5 to 14.5 V
Display Htg.bC.ON/Htg.bC.OFF (alternating)
Specification: between 0.0 to 12.0 V fluctuating
-
Switch ignition off.
If the specification is not obtained:
