Jetta GLS Wagon L4-1.8L Turbo (AWP) (2002)
Basic setting 60
->
xxx%
xxx% 8
ADP.OK.
Adapting has been performed successfully.
-
End engine basic setting by pressing -> key.
-
Press keys 0 and 6 for function "End output" and confirm entry with Q key.
To store the values:
-
Switch ignition off.
NOTE:
If the basic setting of the control module is interrupted, the cause could be one of the following:
-
The test conditions were not fulfilled.
-
Throttle valve control module or wiring is faulty. Check. See: Electronic Throttle Control Module/Testing and Inspection
After an interruption a code is stored in DTC memory. When next switching on ignition the basic setting is automatically performed again.
Instrument Cluster and ECM, Adaptation (Function 10) Notes
Replacement Of Instrument Cluster And Engine Control Module (ECM), Adaptation (function 10)
If all components are to be replaced, adapt all control modules and use new key set.
Appropriate control modules must be obtained from the parts department based on the Vehicle Identification Number (VIN) and engine code.
Appropriate ignition keys must be obtained from the parts department based on the key number.
-
Install new components.
-
Before adapting components, the VIN must be entered into the control module for the immobilizer. This is only possible with the VAS 5051 tester.
-
Adapt Engine Control Module (ECM).
-
Adapt all ignition keys.
Kick-Down Point, Learning
Kick-Down Point, Learning
Following replacement of the engine control module or the accelerator pedal, vehicles with automatic transmissions must relearn the kick-down point.
Test conditions
-
Ignition on, engine not running
Test sequence
-
Connect VAG1551 scan tool (VAG1552). Switch ignition on and select engine control module with "Address word" 01 (Connecting scan tool and
selecting engine control module). Refer to "VAG1551 Scan Tool See: Powertrain Management/Computers and Control Systems/Tools and
Equipment
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press keys 0 and 4 for function "Introduction of basic setting" and confirm entry with Q key.
Indicated on display
Basic setting
HELP
Input display group number XXX
-
Press keys 0, 6 and 3 for "Display group number 63" and confirm with Q key.
Indicated on display
System in basic setting 63
->
1
2
3
4