Jetta GLS Wagon L4-2.0L (AZG) (2002)
-
Disconnect coolant hose from connecting flange -3-.
-
Remove mounting bolts -4- for connecting flange -3- and remove connecting flange -3- with thermostat -1-.
Installing
Installation is the reverse of removal, observing the following:
-
Lubricate new O-ring -2- with engine coolant.
-
Install connecting flange -3- with thermostat -1- into engine block.
Note:
-
The brace on the thermostat must be almost vertical.
-
Tighten mounting bolt-4-.
Tightening torque: 15 Nm (11 ft. lbs.)
-
Fill with engine coolant