Jetta GLX Wagon V6-2.8L (AFP) (2001)
Rear Door Panel: Service and Repair
Rear Door Trim, Removing and Installing
Rear Door Trim, Removing And Installing
CAUTION: Disconnect battery ground (GND) strap before working on electrical system.
NOTE:
-
Removal and installation of trim is described for right side of vehicle. same instructions apply for removal and installation of trim for left-hand
side.
-
Obtain radio code before disconnecting battery.
Removing
NOTE: Obtain radio code before disconnecting battery.
-
Switch ignition off.
-
Using a flat screwdriver - 2 -, pry out trim - 1 - from handle - 3 -.
-
Remove screws - arrows -.
-
Unclip door trim at sides using Disassembly pliers 3392.
-
Lift door trim upward out of window recess.
-
Unclip cable guide - 1 - using a flat screwdriver - 2 -, pull out bracket - 3 - in direction of - arrow - and unhook cable hook - 4 -.
-
Disconnect harness connector - 3 -.