Jetta GLX Wagon V6-2.8L (AFP) (2001)
Brake Caliper: Service and Repair
Rear Brake Caliper
Rear brake caliper
Notes:
^
When repairing install all parts supplied in repair kit.
^
New brake calipers are filled with brake fluid and pre-bled.
^
Apply a thin coat of assembly lubricant, Part No. G 052 150A2, to brake cylinders, pistons and seals.
^
When repairing, it is essential to appropriately pre-bleed the brake calipers (without brake pads) before installation in the vehicle
1
Self-locking hex bolt, 35 Nm (26 ft. lbs.)
^
Always replace
^
When loosening and tightening counterhold on guide pin
2
Bleeder valve
^
Apply a thin coat of assembly lubricant G 052 1 50 A2 to threads before installing
3
Dust cap
4
Guide pins
^
Grease before pulling on protective cap
5
Protective cap
^
Pull onto brake carrier and guide pin
6
Brake carrier with guide pin and protective cap
^
Replacement part is assembled with sufficient grease on guide pins
^
If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate the guide pins.
7
Protective seal
^
Pull outer sealing lip onto piston