Jetta GLX Wagon V6-2.8L (AFP) (2001)
-
The PRINT button is used for switching on the printer (lamp in button lights up).
Indicated on display (* is displayed alternately):
VAG - On Board Diagnostic
HELP
1 - Rapid data transfer*
2 - Blink code output*
-
Press button 1 for "Rapid data transfer".
-
Continue On Board Diagnostic (OBD) of vehicle system to be tested as described under "performing On Board Diagnostic (OBD).
Initiating and Checking Control Module Versions
Data Bus On Board Diagnostic Interface, On Board Diagnostic (OBD), Initiating, Checking Control Module Versions
Test requirements:
-
All fuses OK according to wiring diagram
-
Voltage supply OK (at least 11.5 V).
-
Scan Tool VAG 1551 or VAG 1552 connected.
NOTE:
-
Connecting Scan Tool. Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks"
-
The following description applies only to Scan Tool VAG 1551.
-
Switch on ignition.
-
Switch on printer with the PRINT button (indicator lamp in button lights up).
-
Press button -1- to select operating mode 1 "Rapid data transfer".
Indicated on display:
Rapid data transfer
HELP
Input address word XX
-
Press buttons -1- and -9- to input "Gateway" address word 19.
Indicated on display:
Rapid data transfer
Q
19 - Diagnostic Interface for Data Bus
-
Press -Q- button to confirm input.
Indicated on display:
Rapid data transfer
Q
Tester sends address word 19
Indicated on display (example only):
6N0909901 Gateway K <->
CAN 0001
Coding 00007
WSC 00000
Top line:
Part No. of control module
System designation
(Gateway K <-> CAN) 1)
Software level
Bottom line: Coding 2)
Workshop number
1) The Data Bus On Board Diagnostic Interface -J533- in instrument cluster is referred to in the OBD program as "Gateway".
2) Dependant on the control modules connected to the CAN Bus network.
-
Press -> button.