Jetta GLX Wagon V6-2.8L (AFP) (2001)
/Page-1030003.png)
-
Check Fuel Pump (FP) current draw as follows:
-
Reconnect all disconnected fuel lines.
-
Connect multimeter with electrical current probe to wire of 4-pin connector (terminal 1 arrow) from wiring harness.
-
Start engine and let run at idle.
-
Measure Fuel Pump (FP) current draw.
Specified value: max: 8 amperes
NOTE: If disturbance in fuel system is sporadic, test can also be performed during a road test, but a 2nd person is required.
If current draw is exceeded:
-
Fuel Pump (FP) faulty, replace Fuel Pump (FP), see Fuel Pump (FP), removing and installing.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
See: Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Clearing Diagnostic Trouble Codes
-
Generate readiness code.
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
