Jetta GLX Wagon V6-2.8L (AFP) (2001)
/Page-2598002.png)
^
Loosen window regulator clamp bolts but DO NOT remove.
^
Pull glass free of rubber isolators and remove glass.
^
Clean glass where it inserts into window regulator clamps with 3M® General Purpose Adhesive Cleaner Part No: 08987. See Required Parts and
Tools
^
Remove rubber isolators, see Repair Manual Group 64, Glass, Window regulators, Door windows.
^
Scuff each rubber isolator, where they contact glass, with 120 grit sand paper to remove gloss.
^
Clean scuffed area with 3M(R) General Purpose Adhesive Cleaner Part No: 08987. See Required Parts and Tools
^
Apply a 10mm diameter spot of 3M(R) Channel Bonding and Sidelite Adhesive, Part No. 08641, see Required Parts and Tools, to one side of the
rubber each isolator.
Tip:
Adhesive application tool is available locally.
^
Reinstall isolators into window regulator clamps.
^
Install glass into window regulator clamps, see Repair Manual Group 64, Glass, Window regulators, Door window adjusting.
^
Apply Loctite 242(R) (obtain from local supplier) to exposed bolt threads.
^
Tighten each window regulator clamp bolt to 11 Nm (97 in. lbs.).
^
Close and clean window.
Tip:
Do Not operate window for 30 minutes. This will allow adhesive to cure.
