Jetta III L4-1.9L DSL Turbo (AAZ) (1993)
13
Brake pedal clip
-
Removing, refer to Removal below
14
Nut
-
Tighten to: 20 Nm (15 ft lb)
15
Clip
16
Clip
17
Bracket
Procedures
Pedal Shaft Position
Fig. 1 Installation Position Of Pedal Shaft
-
Cut-down section (arrow) is on left-side.
Fig. 2 Removing Clutch Pedal
-
Pry out clip tab using screwdriver (arrow -1-).
-
Press clip in direction of arrow -2-.
Brake Pedal From Booster Rod Disconnecting
Brake Pedal, Separating From Brake Booster
-
Remove trim under instrument panel on left-side.
-
Remove brake light switch from bracket.
-
Push brake pedal toward vacuum brake booster, and hold.
1 - Brake pedal
2 - Push rod